Table of Contents
Advertisement
In Commercial Confidence
Modem Hardware Installation
Follow procedure Procedure 2-1 and Figure 2-1 to install your modem, set up the cables, computer,
telephone and Splitter.
Note:
Install the ADSL USB Modem by following Procedure 2-1 with the PC running:
ADSL USB Modem - User Manual
FTEL
Do not connect the ADSL USB modem to the computer.
Figure 2-1: Connecting the Modem
Procedure 2-1: Modem Hardware Installation
1.
Locate the master telephone wall outlet and unplug any telephone cable that is
connected to the outlet.
2.
Plug the Splitter into the wall outlet.
3.
Plug in the cable from the Splitter to Modem (the ADSL jack).
4.
Put the square end of the USB cable near the USB port of the ADSL USB Modem to
check that it will reach. Do not plug it in yet, further instructions will tell you when to
plug it in.
5.
Insert the rectangular end of a USB cable into the USB port of your computer.
6.
Connect the telephone wiring to the Splitter.
Installation and Software Setup for PCs Running Windows
Page 2 - 5
Issue 02 March 02
Advertisement
Table of Contents
