Canon RE-350 Control Interface Commands Manual page 10

1.3.2 Procedure for Using the RS-232C Serial Interface
Operations
Order
With the shutter speed switch, set the
1
shutter of the
RE-350
2 Set an number for this
ID
the switches on the rear panel.
DIP
3 Set communication speed for
with the switches on the rear panel.
DIP
Properly connect the
4
with an approved serial cable.
5 Turn on the
PC
done after the
RE-350
6 Turn on the main power of the
Set the
7
RE-350
In order to put the
Mode, the following two methods will be
available:
1. Push the {
on the front panel.
2. The PC sends an [O
or [N
.
using
RE-350
RS-232C I/F
to the
RE-350 PC
. (This operation may be
is turned on.)
.
RE-350
to [O -L ] Mode.
N INE
in [O -L ]
RE-350
N INE
} button
RS-232
-L ]
N INE
] command.
OTIFICATION
RE-350's Condition and LED Status
1. The power on the
LED RE-350
2. Automatically the
RE-350
3. The White Balance will be adjusted automatically and the
White Balance will blink while finding a proper
LED
white balanced setting. If the
proper setting, the White Balance
setting is found, the
LED
4. The will start to find the point of focus, the Auto
RE-350
Focus will be blinking. Once the appropriate point
LED
of focus is found, the Auto Focus
the will be off.
LED
1. The will send Request On Line event data to the
RE-350
, the will blink.
PC RS-232 LED
2. After the reception of <Accepted> E-response data, the
's status shifts to [O
RE-350
will turn on. If the
232 LED
E-response data, the
RE-350
Mode and turns the
RS-232 LED
(Refer to Section 2.5)
The responds with C-response data and its status
RE-350
shifts to the requested mode and turns the
will be turned on
will be initialized.
can not find a
RE-350
will be off, if
LED
will be on.
will be on, if not,
LED
-L ] Mode and the
RS-
N INE
receives <Denied>
RE-350
remains in [O -L ]
FF INE
off.
RS-232 LED
on.
10