2. Put the TY-spring washer, TY-idle gear, and felt (stick onto the TY-idle gear) on the
shaft.
3. Attach the TY-planet gear to the TY-planet gear holder. Put the TY-planet gear
holder on the shaft and push it until the hooks engage.
4. Incline the roller guide R and push the cut-out and align the roller guide R with the
boss hole A to engage with chassis R.
5. Incline the edging saddle EDS-1 and push it into position.
6. Align the Y-sensor lever hook with boss hole B in the chassis R and push it into
hooking position.
7. Align the leaf switch Y assy with the chassis R boss hole C and fasten it in position
with the leaf switch Y screw. Install the contacts of the leaf switch Y assy over the Y-
sensor lever.
Y-sensor lever
Boss hole B
Y-sensor lever hook
Boss hole C
Fig. 4.4-2
Roller guide R
Leaf switch Y assy
TY-spring washer
TY-idle gear
Reassembling the Right Side of the Chassis (2)
4-5
Edging saddle EDS-1
Boss hole A
TY-planet gear
Leaf switch Y screw
Felt
TY-planet gear holder