DeWalt DG series Instruction Manual page 28

CoDE poSSIBlE CauSE
7 Defective capacitor
8 Faulty power cord
9 GFCI switch breaker tripped
10 Generator overloaded
11 Faulty cords or equipment
12 Insufficient ventilation
13 Faulty solenoid
14 Faulty idle control switch
Faulty windings in stator
15
16 Faulty circuit board
17 Faulty wire harness
18 Voltage selector in the 120V position
poSSIBlE SolutIon
Contact a D WALT factory service center or a D
e
service center.
Repair or replace cord
Depress and reset
Reduce load
Check for damaged, bare or frayed wires on equipment. Replace.
Move to adequate supply of fresh air
Contact a D WALT factory service center or a D
e
service center.
Contact a D WALT factory service center or a D
e
service center.
Contact a D WALT factory service center or a D
e
service center.
Contact a D WALT factory service center or a D
e
service center.
Contact a D WALT factory service center or a D
e
service center.
Place the voltage selector to the 240V position when using a tool
that requires 240V.
28
WALT authorized
e
WALT authorized
e
WALT authorized
e
WALT authorized
e
WALT authorized
e
WALT authorized
e