Table of Contents
Advertisement
3. Place your appliance over a sink or
bucket.
4. Lean the appliance on the opposite
side of the ilter opening.
5. Unscrew the scale collector (4) and
take it out.
6. (model dependent)
To wash the ilter, you may:
a. Place the ilter under the water tap
and wash it up until calc residues
are removed. Squeeze the ilter as
indicated in the picture E.
b. Immerse the ilter in tap water (250
ml) mixed with a measure (25 ml)
of descaling luid.
The descaling luid can be obtained
from our After-sales service or from
our website.
Accessory code
(After-sales)
311144
7. Holding your steam generator in the
lateral position and using a jug, ill
the boiler with 1/4 litre of water and
replace the ilter.
8. Shake the base unit for a few
moments, unscrew the ilter again
and empty the boiler completely over
a sink or bucket.
For best results, we recommend that
this operation is performed twice.
Important: before re-closing, make
sure no water remains in the boiler.
9. Replace and tighten up the ilter.
To reset the "Calc'n'Clean" counter,
switch the steam station off twice,
keeping it off for at least 30 seconds
each time.
(on → 30s off → on → 30s off → on)
1
~ 2 h.
¼C
Name of accessory
(Online shop)
TDZ1101
2
³
3-4
a
6
7
0,25 L.
8
9
Rinsing the iron
13
steam chamber
Caution! Risk of burns!
This procedure helps to remove scale
particles out of the steam chamber.
This cleaning procedure may be
performed occasionally (approximately
once a year), when after a long period
of use with very hard water, scale
particles start to come out of the
soleplate.
5
b
25 ml
250 ml
x2
B OS CH
11
Advertisement
Table of Contents
