HP D7171A - NetServer - LPr Frequently Asked Questions page 4

A10. Interface
IDE
Floppy
UW U3 SCSI
Channel A
*Both SCSI channels (A and B) can support up to 14 devices, however there are only enough
bays to plug 3 Hot-Swap HDD. Channel B is to install external SCSI devices.
What utility is used to configure the embedded SCSI controller configuration?
Q11.
The BIOS has the SCSI configuration utility. SCSI configuration is used for configuring
A11.
embedded SCSI controllers and devices connected to the SCSI controllers. Features provided
using this utility include the option of reassigning the designation of channel A and B, verify
or modify SCSI host adapter settings, to low-level format SCSI disks, or verify SCSI media.
Are High Voltage Differential (HVD) devices supported in the NetServer lp 1000r?
Q12.
A12. High Voltage Differential SCSI devices are not supported on the embedded SCSI bus. The
devices will be damaged if connected to the embedded SCSI bus.
What are the supported modes of racking NetServer lp 1000r?
Q14.
A14. Lp 1000r ships with rails (similar to LPr) to be mounted on HP rack or 4 post racks. Refer to
chapters 7, 8 and 13. A separate set of mounting brackets are provided for cantilever
mounting and flush mounting on a Telecommunications (Telco) rack.
What is the maximum number of PCI cards supported by NetServer lp 1000r?
Q16.
It supports one 64-bit full size PCI card.
A16.
Q18. Which Disk Array Controller (NetRAID) card is supported in the NetServer lp 1000r?
HP recommends ONLY using the NetRAID 1Si (D2140A) PCI board in the NetServer
Q18.
lp 1000r.
Q19. What are the supported video display modes? Is an IRQ assigned by default to embedded
video?
A19. Resolution
Max number of devices
supported
1
1
Up to 3* Hot – Swap
HDD slot 1,2,3 Low-
Profile (LP)
Max Refresh Rate @
Installed devices and addresses
Factory installed slim CD-ROM drive
Factory installed slim floppy drive in shelf 4
Embedded SCSI controller (address=ID 7)
Max Refresh Rate @ Max Refresh Rate @