HP D7171A - NetServer - LPr Frequently Asked Questions page 2

HP NetServer lp 1000r Frequently Asked Questions
Which Processors are supported in the NetServer lp 1000r
Q1.
A1. The NetServer lp 1000r supports Intel Pentium III 866 MHz, P III 933 MHz and PIII 1 GHz
processors.
What is new on the front panel of the NetServer lp 1000r?
Q2.
A2. The front panel from left to right has:
Reset button
This switch is to reset the NetServer.
Over temperature LED
This LED indicates green when normal and amber for warning over temperature
conditions.
Fan Fail LED
This LED indicates green when normal and amber for warning one of the fans may be
turning too slowly.
Disk 0 LED
Off when no drive present, steady green when drive present, steady red when drive
failure detected, alternating green/red at 1 Hz when drive is being rebuilt and alternating
green/red at 3 Hz when drive is being identified.
Disk 1 LED
Off when no drive present, steady green when drive present, steady red when drive
failure detected, alternating green/red at 1 Hz when drive is being rebuilt and alternating
green/red at 3 Hz when drive is being identified.
Disk 2 LED
Off when no drive present, steady green when drive present, steady red when drive
failure detected, alternating green/red at 1 Hz when drive is being rebuilt and alternating
green/red at 3 Hz when drive is being identified.
SCSI Activity LED
Green LED indicator flashes during any SCSI disk drive activity.
The Power ON/Off/Sleep button
The power button acts as both a button for transitioning the system between the off and
on states, and a button for transitioning the system between the on and sleep state
Power Indicator LED
This green LED indicator remains steady on when the system is running, and off when
the system is off. This indicator blinks once per second in sleep mode.
Q3. What are the available ports and connectors on the rear of the NetServer lp 1000r