HP D7171A - NetServer - LPr Software Install Manual page 20

MD HPTEMP
CD HPTEMP
B) Insert the "Drivers/Utilities" diskette in drive A of the workstation, and enter the
following copy commands:
COPY A:\7800\AIC7870.ADD
COPY A:\7700\AIC7770.ADD
COPY A:\HPDA\HPDA.ADD
COPY A:\NETRAID\MRAID.ADD
COPY A:\UPDATE.EXE
C) Remove the Drivers Diskette from drive A, and insert the "Work Diskette 1". Delete the
following files to make room on "Work Diskette 1" for new drivers by entering the following
commands:
DEL IBM2FLPY.ADD
DEL IBM2ADSK.ADD
DEL IBM2SCSI.ADD
DEL AHA*.ADD
Copy new drivers to "Work Diskette 1," by entering the following command:
COPY *.* A:\
You may delete all the files in the C:\HPTEMP directory and also delete the C:\TEMP
directory.
Now you are ready to start the OS/2 Installation.
Phase 3: Start Installation
5. Start installation of OS/2 using IBM "Installation" Diskette.
To begin installing OS/2 Warp or OS/2 Warp Connect, place the Installation Diskette in
drive A, insert the IBM OS/2 CD-ROM and boot the system.
6. Insert "Work Diskette 1" when prompted for IBM Diskette 1.
When you are prompted to insert Diskette 1 and press Enter, insert the copy of "Work
Diskette 1" created with the Drivers/Utility diskette, then press Enter. An OS/2 logo appears,
and after some time you will see a screen titled "Welcome to OS/2". Press Enter again to
continue.
Select "Advanced Installation" if you want to partition your drives. Follow the prompts to
create partitions as needed.
20