HP D5970A - NetServer - LCII Manual page 54

Chapter 3
If you receive an error message during the boot process, refer to
"Troubleshooting" in the HP NetServer LH 4/LH 4r User Guide or the
online help. Some power-up (boot) messages are routine.
2. As soon as you see the message
Press Ctrl-C to start Symbios Configuration
Utility...
on the display monitor, press the CTRL+C keys.
NOTE
If you wait too long to press the CTRL+C keys, you may not be
able to enter the Symbios Configuration utility, even though the
message "Press Ctrl-C to start Symbios Configuration Utility..."
is still displayed. If this happens, restart the NetServer, and
press the CTRL+C keys as soon as the message appears.
3. When the Symbios Logic SCSI Configuration Utility Main Menu is
displayed, verify that shows Display=Verbose. (This means that the non-
RAID SCSI devices will be listed on the boot screen.)
If not, use the up and down arrow keys to highlight Display=Terse. Press
ENTER to change the setting to Verbose.
4. On the Symbios Logic SCSI Configuration Utility Main Menu, verify that
the Current Status of all Symbios controllers (adapters) is On.
If not, use the up and down arrow keys to highlight Change Adapter
Status. Press ENTER to display the Change Status on Next Boot window.
Use the up and down arrow keys to highlight the controller, and press
ENTER to change its Next-Boot Status to On. Press ESC to return to the
Main Menu.
5. On the Symbios Logic SCSI Configuration Utility Main Menu, use the up
and down arrow keys to highlight Adapter Boot Order. Press ENTER to
select it.
NOTE
If Adapter Boot Order is inoperative ("whited out"), only one
SCSI channel is operating in non-RAID mode. To operate both
channels in non-RAID mode, refer to "Run Setup Utility" in
this chapter.
50
Configure Mass Storage