HP D5970A - NetServer - LCII Installation And Configuration Manual page 98

[xxxxx020] Adapter or target device not responding or not connected
The target device did not respond to the adapter. If the device is present, refer to
your host adapter's user's guide for troubleshooting information. If the device is
no longer connected to the system, ignore this error.
[xxxxx021] Target device protocol error
An unexpected event occurred during data transfer between the adapter and
target device. Normally, this indicates a faulty or non-compliant target device.
[xxxxx022] Adapter or target device protocol error
The adapter or target device has broken the communication protocol. A badly
behaving device could cause this message to appear. Normally this is not a
serious problem. If you get this message frequently over a short period of time,
it could indicate that the device or system is malfunctioning. Unplug or power
down unused devices to see if the problem persists.
[xxxxx023] Target device parity error
The driver has detected a parity error by the target device. Try decreasing the
transfer rate or disable the Ultra SCSI speed in SCSISelect
you are using twisted-pair SCSI cables.
[xxxxx024] Data overrun or underrun
The adapter was given more or less data than was expected.
[xxxxx030] Target device busy
The target device reports a Busy status. Another program might already be
using this device.
[xxxxx031] Target device queue full
The target device internal buffer is full.
[xxxxx032] Target device busy
The target device reports a Busy status. Another program may already be using
this device.
92
®
. Also, make sure