10 Installing Optical Disk Drives; Installing An Odd In An Hp Z400 Workstation; Installing An Optical Drive (Mini-Tower Configuration) - HP Z600 - Workstation - 6 GB RAM User Manual

10 Installing optical disk drives

This section describes how to install an optical disk drive (ODD) in the workstation.

Installing an ODD in an HP Z400 Workstation

This section describes how to install an optical disk drive in the HP Z400 Workstation in the mini-tower
and desktop configurations.

Installing an optical drive (mini-tower configuration)

1. Follow the procedures described in
workstation for component installation.
2. If necessary, remove the blank filler and the EMI filler from the optical bay.
3. Install the four black metric M3 guide screws into the drive (1).
4. Align the screws with the grooves in the drive bay and gently slide the drive into the casing while
lifting the green drivelock release lever. When the drive is partially inserted, release the drivelock
release lever and slide the drive completely into the bay until it snaps into place.
CAUTION:
drive to see if it can be easily disengaged. Failure to properly secure the drive can damage the
drive when moving the workstation.
5. Connect the power and data cables to the optical disk drive and system board as shown in the
following figure. Refer to the side access panel service label for the location of the SATA
connectors. Connect the data cable in the next available connector.
Figure 10-1
6. Replace all components that were removed in preparation for component installation.
58 Chapter 10 Installing optical disk drives
Preparing for component installation on page 40
Verify that the optical disk drive is secure in the workstation chassis by pulling on the
Connecting ODD power and data cables
to prepare the
ENWW