Preparing For Component Installation; Disassembly And Installation Preparation; Preparing The Workstation For Component Installation - HP Z600 - Workstation - 6 GB RAM User Manual

6

Preparing for component installation

To facilitate the installation of components, several steps can be taken to prepare the workstation. This
section describes how to prepare your workstation for component installation.

Disassembly and installation preparation

Use the following table to determine the order of workstation disassembly required before installing
components. (Your workstation components may be different than those listed.)
Table 6-1
To install...
Memory
Expansion card
(PCI/PCIe)
Hard drive
Optical drive
* See the workstation Maintenance and Service Guide for chassis lock locations and operation instructions.

Preparing the workstation for component installation

To prepare the workstation:
NOTE: The workstation contains green, plastic touch points at locations where you must manipulate
a button or lever. Green touch points on some components indicate tool-less removal of those
components.
1. Disconnect power from the system.
2. Unlock the side access panel or remove any chassis locks.
3. Remove the side access panel as shown in the following illustrations.
40 Chapter 6 Preparing for component installation
Workstation component installation
Remove...
Chassis locks
*
Chassis locks
Chassis locks
Chassis locks
Then remove... Then remove...
Side access Air flow guide
panel (Z800, and
optional on Z400)
Side access Air flow guide
panel (Z800)
Side access
panel
Side access Front bezel (Z400
panel only)
Then remove... Then remove...
Memory fan or
airflow guide (if
required)
Expansion card Expansion card
support slot cover
Air flow guide Expansion card
(Z800 and support (Z800)
optional on Z400)
ENWW