Canon DW-100 User Manual page 21

o
IMPORTANT
• Observe the following precautions while the
firmware is being transferred to the camcorder.
- Do not disconnect the USB cable and do not
push the DVD Burner's disc tray closed.
- Do not turn off the camcorder or the DVD
Burner.
- Do not disconnect the compact power adapter
from the camcorder.
• Never insert the HG10 System Update Disc
CD-ROM to any device other than the Canon
DW-100 DVD Burner. Canon shall not be liable
for any damage or malfunction caused by the'
use of the supplied CD-ROM with any other
device.
CD
NOTES
No other operations can be performed on the
camcorder while the firmware is being transferred.
Updating the HG1 D's Firmware
In this step you will update the camcorder's
firmware to the new version you transferred in
the previous section.
1
Move the
I~
/0 switch to 0 (Still images).
2
Press [FUNC.] then press. or
~
to select
[l1l:al
MENU] and press
@.
3 Press • or ~ to select [SYSTEM SETUP]
and press
@.
4
Press. or
~
to select [FIRMWARE
1.0.0.0] and press
@.
The last digit in the firmware version may be
a number other than
O.
5
Press ~ to select [OK] and press
@.
• The CARD access indicator will flash as the
camcorder updates the firmware.
• Do not turn the camcorder off or
disconnect the compact power adapter
while the firmware's update is in
progress. Doing so will result in a
malfunction of the camcorder.
6
Check that the firmware update was
completed correctly.
• After about 3 minutes, the CARD access
indicator will go off and the camcorder will
restart automatically in still image playback
mode.
• After the firmware update, the camcorder
is reset to initial settings. In order to use it,
you will need to readjust the camcorder's
internal clock and change the language as
necessary.
o
IMPORTANT
• Do not touch or operate any of the camcorder's
controls (buttons, switches, dials, etc.) during the
firmware update.
• If the camcorder's firmware is not updated
correctly contact a Canon Service Center.
CD
NOTES
• After the firmware update, the camcorder is reset
to initial settings.
• You can verify that the firmware was updated
correctly by opening the [SYSTEM SETUP] menu
as described in steps 1-3. Check that the
firmware's version changed to 1.0.1.0.
• If [FIRMWARE 1
.a.a.x]
appears grayed out in
step 4 or the firmware upgrade option does not
appear in step 5, the new firmware may not have
been transferred correctly to the camcorder
(CD 3). In such case, do the following.
- Turn off the camcorder and the DVD Burner
and disconnect the USB cable.
- Disconnect the DVD Burner's power adapter.
After a short while, reconnect the power
adapter and turn on the DVD Burner.
- Transfer the new firmware again, starting the
procedure from the beginning (CD 2).
3
I