Drying; Cleaning The Fluff Filter; Removing The Laundry - Bosch WTW84160GB Installation Instructions, Instructions for Use, Programme Table Instruction Manual

specting the
dryer
nnecting the
mains plug
oading laundry
he programme
1
drying programme ...
2
idual requirements
sitive and only
d lightly.
Start/Stop button
3
with the fluff filter
0, 1, 2, 3
Do not pull out/empty the
condensation container when drying is in progress.

Drying

Condensation container with filter
Control panel
Drum
Two-part
fluff filter
Air inlet
Drying
Emptying condensation
Empty the container after each drying cycle, not during drying.
1. Remove the condensation container and hold it level.
2. Pour out the condensation.
3. Always push container in fully until it clicks into place.
If the Container indicator lamp flashes despite the container having been
emptied Filter in condensation container, page 9.

Cleaning the fluff filter

The fluff filter consists of two parts.
Clean the inner fluff filter after every drying cycle.
1. Open the door. Remove fluff from the door/door area.
2. Pull out the inner fluff filter and open it out.
Remove the fluff (by wiping the filter with your hand).
3.
If the fluff filter is heavily soiled or blocked, rinse it under
running water and dry thoroughly.
Clean the outer fluff filter after every 5 drying cycles:
4. Remove the outer fluff filter.
5. Open it and remove any fluff.
Rinse under running water and dry thoroughly.
6. Close and re-insert the fluff filter.
Switching off the dryer
Turn the programme selector to Off.
Do not leave laundry in the dryer.

Removing the laundry

Your dryer is equipped with an automatic reduced ironing function. The drum is moved at specific time
intervals for 60 minutes once the programme has ended. The laundry stays loose and fluffy
(or 120 minutes if the additional Less ironing function is selected (depending on model)).
End of programme
as soon as the Anti-Crease/End indicator lamp
lights up.
Interrupt programme
Adding or removing laundry.
The drying operation can be interrupted briefly to add or remove laundry. However, it must then be
continued until it has finished.
1. Open the door. The drying process is interrupted.
2. Add or remove laundry then close the door.
3. If required, select a new programme and additional functions.
4. Press the Start /Stop button.
3 4