Bosch WTW84160GB Installation Instructions, Instructions for Use, Programme Table Instruction Manual page 2

Installation Care and cleaning
Heat exchanger
– Scope of delivery: dryer, installation and operating instructions.
– Check dryer for transport damage.
The dryer's heat exchanger is cleaned automatically during drying.
– The dryer is very heavy. Do not attempt to lift it on your own.
Do not pull out the condensation container during the cleaning process.
– Be careful to avoid sharp edges.
– Do not set up in a room that is susceptible to frost. Freezing water may cause damage. Dryer housing, control panel, air intake
– If in doubt, have the appliance connected by a specialist.
Wipe with a soft, damp cloth.
– Do not lift the dryer by protruding parts (e.g. the door) - risk of breakage.
Do not use harsh cleaning agents or solvents.
Setting up the dryer
1. Take all accessory parts out of the Remove detergent and cleaning agent residue immediately.
– The appliance plug must always be accessible.
drum. The drum must be empty.
– Ensure that the appliance is installed on a clean, level Filter in the condensation container
and firm surface.
The filter is cleaned automatically when the condensation container is emptied.
– Do not obstruct the air inlet on the front of the dryer.
However, the filter should still be cleaned regularly under running water
– Keep the area around the dryer clean.
stubborn deposits/dirt from building up.
– Make the dryer level using the threaded feet
and a spirit level.
– Do not remove the threaded feet under any
circumstances. 1. Pull out the condensation container.
Do not set up the dryer behind a door or sliding door, as this may obstruct
the dryer door or prevent it from opening. This will prevent a potentially
fatal danger to children from locking themselves in.
Mains connection see Safety instructions page 13.
2. 2. Pull the filter out of its snap-in lock.
– Connect to an AC earthed socket. If in doubt have the
socket checked by a specialist.
– The mains voltage and the voltage shown on the rating
page 10) must be the same. Clean and level
plate (
– The connected load and necessary fuse protection are
Make sure that the air inlet
specified on the rating plate.
remains unobstructed
Frost protection / Transport Do not operate the dryer if
3. Clean the filter under running water or in the dishwasher.
there is a danger of frost.
Frost protection - preparation
1. Empty the condensation container page 4.
2. Select any programme using the programme selector.
3. Press the Start/Stop button condensed water is pumped into
the container
4. Wait 5 minutes and then empty the condensation container again.
4. Refit the filter.
5. Turn the programme selector to Off.
Transport
– Prepare the dryer see Frost protection - preparation.
5. Insert the condensation container so that it locks into place.
– Transport the dryer in a vertical upright position.
– Following transportation, do not use the dryer for two hours.
The dryer contains residual water; Only operate the dryer with the filter inserted.
this can flow out if the dryer is tilted.
Moisture sensor
Signal
The dryer is equipped with stainless steel moisture sensors. Moisture sensors measure how
damp the laundry is. A thin layer of limescale may build up on the moisture sensors after
Switching on/off an acoustic signal at the end of the programme
prolonged use.
1. Open the door.
2. Clean the moisture sensors using a damp sponge with a rough surface.
Do not use steel wool or abrasive materials.
Turn to 1 x to the Press and hold Low heat Press Low heat to Turn to
Off right and turn 3 x to the right switch on/off the signal Off
Low Heat light on an acoustic signal at the end of the programme is switched on.
Low Heat light off an acoustic signal at the end of the programme is switched off.
8
Appliance must be switched off.
Technical data
Dimensions (DxWxH) 60 x 60 x 85 cm (height adjustable)
Weight approximately 51 kg
Max. capacity 7 kg
Condensation container 4.0 l
Connection voltage 220-240 V
Connected load max. 1000 W
Fuse protection 10 A
Ambient temperature 5 - 35°C
Product number
This prevents under the door
Production number
The rating plate can be found on the back of the dryer.
Drum interior light (depending on model) (bulb E14, 25 W)
The drum lights up after the door is opened or closed, and after the programme starts,
and switches off automatically. Changing the bulb page 12.
Consumption rates
Residual moisture in the fabrics Energy
Fabrics/programmes Drying time**
after spinning consumption**
Cottons 7 kg
Cupboard Dry* 1400 rpm (50%) 134 min 1.75 kWh
1000 rpm (60%) 155 min 2.03 kWh
800 rpm (70%) 175 min 2.32 kWh
Iron Dry* 1400 rpm (50%) 98 min 1.24 kWh
1000 rpm (60%) 119 min 1.52 kWh
800 rpm (70%) 139 min 1.81 kWh
Easy-Care 3.5 kg
Cupboard Dry* 800 rpm (40%) 54 min 0.57 kWh
600 rpm (50%) 68 min 0.72 kWh
* Programme setting for testing in accordance with applicable standard EN61121.
** The values may differ from those specified, depending on the type of fabric, composition of
laundry to be dried, residual moisture in the fabric and the amount of laundry being loaded.
Fabrics/programmes Drying time Annual energy consumption
Cottons 7 kg / 3.5 kg*
Cupboard Dry*** 124 min / per cycle 258 kWh / per year
***Programme setting for testing and energy labelling in accordance with Directive 2010/30/EU.
Optional accessories
(from after-sales service using order number)
Washer-dryer stack connection set
WTZ
The dryer can be placed on top of a suitable washing machine with the same width and depth
11310
to save space. The dryer must be fastened to the washing machine using this connection set.
WTZ 11300: with pull-out worktop.
Installation underneath the worktop
WTZ
Instead of the appliance covering plate, you must have a metal cover fitted by a specialist.
10290
WMZ Platform
20500 For easier loading and unloading. The basket contained in the drawer can be used
to carry the laundry.
9
Normal noises What to do if...
If you cannot rectify a fault yourself (e.g. switching off/on) , please contact our after-sales
During drying, the compressor and the pump generate some noise which is entirely normal.
service. We will always find an appropriate solution and will avoid unnecessary visits by
engineers. Trust the expertise of the manufacturer and rest assured that the repair will be
carried out by trained service technicians using original spare parts. The contact details of your
local after-sales service can be found in the enclosed after-sales service directory, or by calling
one of these numbers:
The compressor in the dryer may – GB 0844 892 8979 (Calls from a BT landline will be charged at up to 3 pence per minute.
A call set-up fee of up to 6 pence may apply.)
occasionally generate a humming noise.
The volume and pitch of this may vary
– IE 01450 2655
depending on the selected
When contacting the after-sales service, please quote the appliance's product number (E no.)
programmes and the progress of the
and production number (FD) (see under the loading door).
drying.
Turn the programme selector to Off and unplug the mains plug from the socket.
The Start/Stop indicator lamp
does not light up.
The display panel light and
indicator lights (depending on
model) go out and the
Start/Stop indicator light
flashes.
The Container indicator lamp
The compressor in the dryer is ventilated and the Start/Stop button are
from time to time, which creates a whirring flashing.
sound.
The Clean indicator lamp and
Start/Stop button are flashing.
Dryer does not start.
Water is leaking out.
The door opens by itself.
Creasing.
The automatic cleaning process causes
Drying result is not satisfactory
a clicking noise. (laundry feels too damp).
Drying time too long.
The process of pumping the condensation
into the condensation container generates The humidity in the room
pumping noises.
increases significantly.
Power failure.
Other intermittent noises and
vibrations.
Loud humming noise for several
seconds.
10 11
Safety instructions
Emergency – Pull the appliance plug out of the socket immediately or disconnect the fuse.
ONLY use the – in rooms inside the house.
dryer... – to dry fabrics.
The dryer must – be used for purposes other than those described above.
NEVER... – be modified in terms of its technology or properties.
Hazards – The dryer must not be used by children or persons who have not been
instructed in its use.
– Do not leave children unsupervised near the dryer.
– Keep pets away from the dryer.
– Remove all objects from pockets, and lighters in particular
explosion.
– Do not lean or sit on the door Risk of tipping.
Mains plug plugged in?
Installation – Secure loose cables Risk of tripping.
Programme selected?
– Do not operate a dryer if there is a risk of frost.
Check the socket fuse.
Energy-saving mode is activated see the separate Mains – Connect the dryer to an AC earthed socket according to specifications,
Energy-saving mode instructions. connection otherwise it cannot be guaranteed that the appliance is completely safe.
– The cable cross-section must be sufficient.
– Only use earth-leakage circuit breakers with the following symbol:
– The appliance plug and socket must be compatible.
– Do not use multiple plugs/connectors and/or extension cables.
Empty the condensation container page 4.
Clean the condensation container filter if necessary – Do not touch or hold the appliance plug with wet hands
page 9. Risk of electric shock.
Dryer transported? Wait 2 hours and start again. – Never pull the appliance plug out of the socket by its cable.
– Do not damage the mains lead Risk of electric shock.
Rinse the fluff filter under running water page 4.
Operation – Only load the drum with laundry.
Start/Stop button selected? Door closed? Check the contents before you switch the dryer on.
Programme set? Ambient temperature greater than 5 °C? – Do not use the dryer if the laundry has been in contact with solvents, oil, wax,
Make sure the dryer is level. grease or paint (e.g. hair styling products, nail varnish remover, stain
remover, cleaning solvent, etc.) Risk of fire/explosion.
Push the door closed until you hear it click into place. – Dust (e.g. coal dust, flour) poses a danger: Do not use the dryer
Risk of explosion
Laundry load exceeded?
– Do not put laundry containing foamed material/rubber in the dryer
Remove articles of clothing immediately after the end of the
material may be destroyed and the dryer be damaged due to possible
programme, hang up and pull into shape.
deformation of the foamed material.
Unsuitable programme selected page 7.
– When cleaning the fluff filter, make sure that no foreign material (down or
Warm laundry feels damper than it actually is.
filling material) gets into the air duct opening. If necessary, clean the drum
The selected programme does not suit the load.
beforehand with a vacuum cleaner. If foreign material should still get into the
Use another drying programme or, in addition, select the
air duct call the after-sales service Risk of fire/explosion.
time programme page 7.
– Switch off the dryer once the programme has ended.
Use fine adjustment for the drying result
page1/2 and 6. – The water from condensation is not drinking water and may be contaminated
with fluff.
Fine layer of limescale on the humidity sensors
Clean the humidity sensors page 9. Defect – Do not use the dryer if it is defective or if you suspect that it is.
Programme termination, e.g. tank full, mains power supply Repairs must only be carried out by the after-sales service.
failure, door open or maximum drying time reached.
– Do not use the dryer if the mains cable is defective. To avoid danger, only
Rinse the fluff filters under running water page 4. have the defective mains cable replaced by the after-sales service.
Insufficient supply of air ensure that air can circulate.
– Always pull the mains plug out of the socket before changing the bulb for
Air inlet possibly blocked Clear inlet page 8.
the interior light Risk of electric shock.
Ambient temperature higher than 35 °C ventilate the
Spare parts – Only use genuine spare parts and accessories for safety reasons.
room.
Make sure the room is sufficiently ventilated. Disposal – Pull out the appliance plug, then cut off the mains cable from the appliance.
Dispose of at a municipal waste disposal facility.
– Heat exchangers contain a fluorinated greenhouse gas covered by the
Remove laundry from the dryer immediately and spread out.
Kyoto protocol (R134a) dispose of in a proper manner.
This allows the heat to dissipate.
Capacity: 0.22 kg.
Not an error.
– Packaging: Keep all packaging out of reach of babies and children
Normal noises page 11.
Risk of suffocation.
Has the condensation container been properly inserted?
– All materials are environmentally sound and can be reused.
Push the condensation container all the way in.
12 Dispose of in an environmentally-responsible manner.
Not an error. Normal noises page 11.
Risk of
elastic
Dryer
en Instruction manual
13