Installing Memory Boards - HP Integrity rx4610 User Manual

Chapter 5: Installing Additional Memory
9. Place the memory board on a clean ESD-protected surface.

Installing Memory Boards

Two memory boards exist, one plugged into each side of the Processor Baseboard (the top and the
underside of the Processor/Memory Complex). This procedure describes the installation process for
either memory board. To re-install the memory board or install a new board, complete the following
procedure:
1. Observe all safety and ESD precautions.
2. Remove the Processor/Memory Complex as described in "Removing the Processor/Memory
Complex" in Chapter 5.
3. With both extraction levers raised to engage the guide pins, place the memory board over the
Processor Baseboard connector and guide pins
4. Engage both guide pins at the same time. Ensure that the memory board remains parallel to
the Processor Baseboard.
NOTE
5. Slowly depress the levers until the Memory Board connector fully engages.
Figure 5-4. Memory Boards
Both extraction levers must be depressed evenly while inserting the Memory
Board. The Memory Board must remain parallel to the Processor Baseboard
during insertion.
40