Hitachi StarBoard FX-DUO-63 User Manual page 21

StarBoard FX-DUO Series
[2] Install the board
CAUTION
Be sure to use two or more people for this work.
Failure to comply may cause the board to fall, resulting in personal injury, or may cause
damage to this product due to shock of impact.
Tighten the screws securely.
Failure to comply may cause the board to fall, resulting in personal injury, or may cause
damage to this product due to shock of impact from the board falling.
Install the board on the stand assembled in step [1]. Install the board according to the
following procedure. Note that this work should be performed by two or more people. The
numbers in the diagram correspond to the numbers in the parts list on page 1-3 of this User's
Guide.
(4)(5)
Board
(6)
(10)
(a) Decide the level (out of six) at
which the board will be installed,
and attach the board receiving
brackets (4) and (5) to the square
holes of the stays on the back of the
board.
(b) Verify that the square holes are
attached securely to the board
receiving brackets on both sides.
(c) Fix the board fixing brackets (6)
temporarily on the stand vertical
supports (1) using the pan head
screws (9).
(d) Tighten the triangular knob screw
(10) to fasten the board to the board
fixing bracket (6) on both sides.
(e) Tighten the pan head screws that
were fixed temporarily in (c).
1-9
Introduction
English