HP 6400/8400 User Manual page 97

Table 21 Error Messages (continued)
Status Code Value
26
Parameter Object Does Not Exist
27
Target Object Does Not Exist
28
Timeout
29
Unknown Id
30
Unknown Parameter Handle
31
Unrecoverable Media Error
32
Invalid State
33
Transport Error
34
Volume is Missing
35
Invalid Cursor
36
Invalid Target for the Operation
37
No More Events
38
Lock Busy
Meaning
The operation cannot be performed because
the object does not exist. This can indicate
a user or program error.
VOLUME set requested usage: The disk
volume set requested usage cannot be
performed because the disk group does not
exist. This can indicate a user or program
error.
Case 1: The operation cannot be performed
because the object does not exist. This can
indicate a user or program error.
Case 2: DERIVED UNIT discard: The
operation cannot be performed because the
virtual disk, snapshot, or snapclone does not
exist or is still being created.
Case 3: VOLUME set requested usage: The
operation cannot be performed because the
target disk volume does not exist. This can
indicate a user or program error.
Case 4: GROUP get name: The operation
cannot be performed because the
Continuous Access group does not exist. This
can indicate a user or program error.
A timeout has occurred in processing the
request.
The supplied storage cell identifier is invalid.
This can indicate a user or program error.
The supplied parameter handle is unknown.
This can indicate a user or program error.
The operation could not be completed
because one or more of the disk media had
an unrecoverable error.
This error is no longer supported.
A SCMI transport error has occurred.
The operation could not be completed
because the drive volume is in a missing
state.
The supplied cursor or sequence number is
invalid. This may indicate a user or program
error.
The specified target logical disk already has
an existing data sharing relationship. This
can indicate a user or program error.
There are no more events to retrieve. (This
message is informational only.)
The command lock is busy and being held
by another process.
How to Correct
Report the error to product support.
Case 1: Report the error to product
support.
Case 2: Retry the request at a later
time.
Case 3: Report the error to product
support.
Case 4: Report the error to product
support.
Verify the hardware connections and
that communication to the device is
successful.
Report the error to product support.
Report the error to product support.
Report the error to product support.
Report the error to product support.
Verify the hardware connections,
communication to the device, and that
the management software is operating
successfully.
Resolve the condition and retry the
request. Report the error to product
support.
Report the error to product support.
Report the error to product support.
No action required.
Retry the request at a later time.
97