Recalculating The Route To Your Destination; Canceling The Route Guidance; Adding Way Points To The Current Route; Adding A Way Point - Pioneer AVIC N2 - Navigation System With DVD player Operation Manual

Recalculating the Route to Your
Destination
You can set the length of the area, and avoid just
that area, or you can even search a new route
from the current location to your destination. (On
the map screen during route guidance, try the fol-
lowing operations.)
1
Touch the map screen.
The Shortcut menu appears.
2
Touch .
The Route/Detour menu appears.
3
Touch "Reroute" or the distance from the
list.
After the route is calculated, the map screen
shows your surroundings and route guidance
is resumed.
On this display, you can select the following
items:
Reroute :
The route from the current position to your
destination is recalculated.
The distance of the detour
(1-50 mile/km) :
Searches detours of a specified distance in
the route ahead of your current position.
➲ For details of switching the display between
"mile"(miles)" and "km" see "KM/Mile Set-
ting" ➞ Page 64

Canceling the Route Guidance

If you no longer need to travel to your destination
or if you want to change your destination, follow
the steps below to cancel the route guidance.
1
Touch "Destination" in the Main menu,
then touch "Cancel Route".
The message confirming whether to cancel
the current route appears.
42
2
Touch "Yes (all)".
The current route is deleted, and a map of
your surroundings reappears.
On this screen, you can also select the follow-
ing items:
Yes (one) :
Route is recalculated by canceling the
selected way point.
➲ Deleting a way point from the route ➞
Page 43
No :
Returns to the previous display without delet-
ing the route.
❒ You can also cancel the route using the
Chg.Route in the shortcut menu.
Adding Way Points to the Cur-
rent Route
You can select way points (locations you want to
visit on the way to your destination) and you can
recalculate the route to pass through these loca-
tions.

Adding a way point

You can add up to five way points. This is
achieved as follows :
1
Specify the location you want to visit.
Specify a way point in the same way as speci-
fying a destination.
At completion of the location search, a mes-
sage is displayed asking whether or not to set
that specified location as the destination, or
as a pass-through location.