Hot Surface Indicator; Using The Element - LG LDE3011ST Owner's Manual

HOT SURFACE INDICATOR

When the surface is too hot to touch
because of the heating element. It will
remain on after the element is turned
off and the surface has cooled to
approximately
150 deg F.

USING THE ELEMENT

To turn on a SINGLE
surface unit:
(Left Rear, Right Rear, Left Front)
Press
flash
(If no further pads are pressed
within 10 seconds, the display will
disappear.)
Press + once to turn on the
power level Hi or – once to
Use the – / + to choose the
desired power setting.
– / + is continuously accessible.
element is ON.)
press
S U R FAC E C O N T RO L S C O O K I N G
for the desired
.
.
once.
CAUTION
cooled down sufficiently.
may occur.
CAUTION
for the element to cycle on and off during cooking.
power is selected however it can also occur on
higher settings as well.
NOTE:
9.0 through 3.0. (by 0.2 from 3.0 through 1.0)
is the lowest power level available.
NOTE:
hold the – or + key pads until the power level
desired is reached.
CAUTION
high setting.
Greasy spillovers may catch on fire.
CAUTION
safe for oven and cooktop use.
Always use oven mitts when removing food from the
warming center as cookware and plates will be hot.
seal. Allow venting for heated air to escape.
Plastic may melt onto the surface and be very difficult to clean.
with a lid or aluminum foil to maintain food quality.
11