List Of Viewer Messages; Messages Displayed In The Information Field - Canon VB-M700F Operation Manual

List of Viewer Messages

Messages displayed in the Information Field

Messages displayed in the information field of the viewer are classified into the following three types.
Icon
Information Message
Warning Message
Error Message
Information Message
Connection closed by the camera.
Audio connection has been closed.
Camera control gained.
Camera control lost.
Warning Message
Could not connect to the camera.
The camera is busy.
Failed to get camera control privileges.
Failed to establish audio connection.
You are not connected to the camera.
Please get camera control privileges.
Another user is already connected as an administrator.
The viewer is already connected in another window.
Cookie is not available or blocked on your web browser.
JavaScript is not available or disabled on your web browser. JavaScript is not available or blocked on your web browser.
No audio device.
Failed to initialize Canon Network Camera Audio
Receiver.
Image display for Viewer PTZ use is restricted.
8
-20
Category
Help messages on various buttons, pull-down lists, etc., as well as frame rate and other
information from the camera are shown.
A message will be displayed notifying the user when camera control privileges cannot
be obtained, the audio session stops, etc.
Displayed when a system error occurs in the viewer.
Message
Message
Explanation
The camera was disconnected.
The video session has continued after the audio session was disconnected
(applicable to both transmission and reception).
Displayed when camera control is obtained. You can operate the camera.
Displayed when camera control is released. You cannot operate the camera
until you get camera control privileges again.
Connection failed due to an invalid IP address, etc.
The connection limit was exceeded.
The request for camera control privileges was denied because the camera
was being used by the Admin Viewer, etc.
Connection for audio reception failed.
An attempt was made to operate the camera when the camera was not
connected.
An attempt was made to operate the camera without camera control privileges.
The Admin Viewer is already connected to the camera.
The viewer is already available in another window.
Cookie is not available or blocked on your web browser.
The [Audio] button has been clicked when there is no audio device or the
audio device has been disabled in the PC.
ActiveX plugin is not installed within ten seconds after clicking the [Audio]
button.
The image display for the Viewer PTZ is restricted by settings in the camera.
Explanation
Explanation