6
SYSTEM PROGRAMMING
6.1
GENERAL PROGRAMMING INSTRUCTIONS
6.1.1
DEFAULT SETTING
This system has default factory settings. If any of the programming needs to be changed,
you can change settings by system programming.
6.1.2
EXTENSION USED FOR PROGRAMMING
System programming can only be performed from extension 801.
6.1.3
BEFORE PROGRAMMING
You need to enter the password to enter system programming.
If extension 801 is in Direct External Dialing Mode, you must dial * before dialing *01 to
enter the password.
6.1.4
PROGRAM A SYSTEM SETTING
Press * to start programming a system setting.
Enter the code and parameters for changing a system setting.
Press # to complete the programming of a system setting.
To correct a wrong system setting, press * to program the system setting again.
There is no need to hang up the telephone.
6.1.5
AFTER PROGRAMMING A SYSTEM SETTING
After programming a system setting, a long "Beep" indicates that the system setting has
been made successfully.
A series of short "Beeps" indicates that the system setting was unsuccessful.
Please check and try again or reset the unit.
23