10. NOTES ON USE AND INSTALLATION
• Do not aim the camera at the sun
• Do not shoot intense light
• Treat the camera with care
• Never touch internal parts
• Do not splash water on the camera
• Keep the camera installation away from video noise
• Check the ambient temperature and humidity
• Should you notice any trouble
11. IN CASE OF PROBLEMS
01_p2-p32
Downloaded from
www.Manualslib.com
Never aim the camera at the sun even with the camera power off.
Intense light such as a spotlight may cause a bloom or smear. A vertical stripe may appear on
the screen. However, this is not a malfunction.
Do not drop the camera or subject it to intense vibration.
Do not touch the internal parts of the camera other than the parts specified.
Install the camera where the camera can be kept dry. If the camera gets wet, turn off the power
and contact your dealer.
If cables are wired near electric lighting wires or a TV set, noise may appear in images. In this
event, relocate cables or reinstall equipment.
Avoid using the camera where the temperature is hotter or colder than the specified operating
range. Doing so could affect the internal parts or cause the image quality to deteriorate. Special
care is required to use the camera at high temperature and humidity.
If any trouble occurs while you are using the camera, turn off the power and contact your dealer.
If you continue to use the camera when there is something wrong with it, the trouble may get
much worse and an unpredictable problem may occur.
Condition
No image
Unnatural color
12
manuals search engine
Check Point
Are the camera and connected equipment turned on?
Is the iris of the lens adjusted properly?
Are cables connected correctly?
Is the monitor TV adjusted correctly?
Is the lighting too dim?
- 12 -
06.8.7, 11:08 AM