Installation - NEC VERSA DOCKING STATION 4000 Manual

Installation

4-8 Adding Options
Follow these steps to install an industry standard, 8- or 16-
bit expansion board in the docking station.
Prepare for board installation as follows:
1.
n
Disconnect and remove the NEC Versa from the
docking station.
n
Turn off and unplug the docking station.
n
Disconnect any peripheral devices connected to the
docking station.
n
Remove the docking station cover. See "Cover Re-
moval" earlier in this section for information on re-
moving the cover.
n
Position the docking station so you have access to the
side where the expansion slots are located.
Expansion slot locations