NEC DSX Software Manual page 120

Conference
Operation
To set up a Conference:
Establish an Intercom or outside call.
1.
Press CONF .
2.
• Your hear Intercom dial tone.
• Your caller hears Music on Hold (if installed) while they wait for you to set up the Conference.
Do one of the following:
3.
a. Dial extension you want to add.
b. Place or answer an outside call.
c. Retrieve a call from Park Orbit.
Press CONF to set up the Conference.
4.
• If you cannot add additional parties to your Conference, you have exceeded the system's Conference limit.
Repeat steps 2-4 to add additional parties to your Conference. You can also do one of the following.
5.
a. To optionally place a Conference on Hold:
b. To reinstate the Conference on Hold.
To exit a Conference without affecting the other parties:
Hang up.
1.
• The remaining parties can continue their conversation uninterrupted.
• If you were in Conference with two outside lines, this may set up a tandem call. Refer to Tandem Calls /
Unsupervised Conference (page 341) for more.
Using Conference at a Single Line Telephone
To use Conference at a single line telephone:
Establish an Intercom or outside call.
1.
Hookflash and dial the extension or outside line you want to add.
2.
Hookflash and dial #10 to set up the Conference.
3.
• If you cannot add additional parties to your Conference, you have exceeded the system's Conference limit.
Repeat steps 2 and 3 to add additional parties to your Conference.
4.
90 ◆ Features
Setting up a Conference
Press HOLD .
Press CONF .
Exiting a Conference
In these instructions:
[Super Display Soft Key]
[Keyset Soft Key]
In these instructions:
[Super Display Soft Key]
[Keyset Soft Key]
In these instructions:
[Super Display Soft Key]
[Keyset Soft Key]
DSX Software Manual