Channel Name - Yamaha CL1 Owner's Manual

C
D
E
F
G
H
I
G
Fader
Adjusts the input level of the INPUT CH, or the send level.
The fader is color-coded and indicates status as follows:
White: You can adjust the input level of the INPUT CH (normal mode.)
Gray: INPUT CH is off.
Other colors: You can adjust the send level (SENDS ON FADER mode.)
The current fader value is shown in the numerical box located immediately below the fader.
You can set this to the minimum value (–∞ dB) by holding down the <Ctrl>(< >) key of your computer keyboard and
clicking the fader knob, or set it to the nominal value (0.00 dB) by holding down the <Ctrl>(< >) key and <Shift> key
and clicking the fader knob.
The numbers and alphabetical letters at the right of the fader indicate the DCA group and mute groups to which that
channel belongs, and show the Recall Safe and Mute Safe status of the channel.
The numbers of mute groups to
which this channel belongs are
shown in red when those groups are
muted. If the dimmer levels for those
groups are set in a non-default sta-
tus, those are shown in orange.
If this channel is set to Mute Safe,
the M character is shown in green.
Click the indicator area to switch between 3 indicators.
NOTE
H
Channel number
This is the number of the INPUT CH. You can open the Selected Channel window for this channel by double-clicking
this number. If you hold down the <Ctrl>(< >) key of your computer keyboard and double-click this, the Selected
Channel window will open as an additional view.
I

Channel name

This is a text box that displays the channel name. You can also edit the channel name in this text box.
C
PAN/ST/M(C)
The PAN knob adjusts the panning of the signal that is sent from the INPUT CH to the
STEREO bus L/R channels (or the L/C/R channels.) You can set this to the center value by
holding down the <Ctrl>(< >) key of your computer keyboard and clicking this knob.
The [ST] button is an on/off switch for the signal that is sent from the INPUT CH to the
STEREO bus.
The [M(C)] button is an on/off switch for the signal that is sent from the INPUT CH to the
MONO bus.
If LCR MODE is selected in the Selected Channel window, the [LCR] button will appear
instead of the [ST] button and [M(C)] button, and the [LCR] button will be an on/off switch
for the signal that is sent from the INPUT CH to the LCR bus.
D
SEL (Channel selection)
Selects the INPUT CH for which you want to perform operations.
E
CUE
This button cue-monitors the signal of the INPUT CH.
If the Channel Select/Sends On Fader checkbox in the System Setup dia-
NOTE
log box is not checked, the [CUE] button will be hidden in the screen.
F
ON
Switches the INPUT CH or send on/off.
The button is color-coded and indicates status as follows:
White: INPUT CH is on (normal mode.)
Black: INPUT CH/Send are off.
Other colors: Send is on (SENDS ON FADER mode.)
Mute Group indicator DCA Group indicator
The numbers of DCA groups
to which this channel belongs
are shown in yellow.
This level meter is displayed
at the same metering point
with the input channel in
Meter window setup (➥ p.67.)
If this channel is set to Recall
Safe, the R character is
shown in green.
14
Level Meter
CL Editor Owner's Manual