Remove The Spacer (For Version With Through Drive) - Bosch Rexroth A10VSNO Instruction Manual

34/60 Installation
Bosch Rexroth AG, A10VO, A10VSO, A10VSNO Series 32, RE 92714-01-B/04.2018
7.4.7

Remove the spacer (for version with through drive)

Fig. 11: Removing the spacer
Axial piston units with through drive are delivery with a spacer (1). The spacer is
designed for transport protection and to reduce the hub's axial clearance (2).
CAUTION! Operation with spacers!
Operating the axial piston unit with spacer may result in damage to the axial piston
unit.
▶ Remove the spacer prior to commissioning.
▶ Remove the spacer (1).
The spacer must be removed before the second pump is fitted. If you operate
the axial piston unit without installing a further pump on the through drive, it
is absolutely necessary to remove the spacer and the hub. Since the metallic
protective cover (3) is not pressure-resistant, it must be replaced with a pressure-
resistant cover. If you need a pressure-resistant cover, contact your Bosch
Rexroth Service partner. Use a suitable tool for this to prevent damage to the
functional surfaces. If functional surfaces are damaged, contact your Bosch
Rexroth service partner or the service department of the plant that manufactured
the axial piston unit.
1
3
2