Table of Contents
Advertisement
This section describes the process between starting the
signal environment monitoring and saving.
For further details on operations, see "[RF Chart
Grapher] Tab" on page 34.
1
Place a check mark next to [Online monitoring and
control] in the [Device] menu.
The system enters online mode, the receivers are
automatically detected and added to the device list
window, and monitoring of the signal environment
starts.
2
When you are finished with operations, click [Save all]
to save the acquired RF and QL data.
The following dialog box appears.
3
Select the folder in which you want to save the data,
and click [OK].
The RF and QL data for all the receiver channels is
saved under the selected folder.
You can display the saved data in the [RF Chart
Analyzer].
For details on the [RF Chart Analyzer], see "[RF
Chart Analyzer] Tab" on page 40.
Using Settings Files
Wireless Studio allows you to save device settings as files.
By recalling the settings stored in a file and applying them
to devices using the [Load settings] function, you can reuse
previously configured settings.
After recalling settings from a file, you can also edit the
setting values in Wireless Studio without connecting to the
devices on the network. You can create new system
configurations that are based on previous setting
environments by applying the settings edited in Wireless
Studio to the devices.
The following items are stored in a settings file.
• Setting values for each device that appears in the device
list.
• Positions of meter icons registered in the status viewer.
• Omit IP address list settings
Saving the settings as files
1
Remove the check mark next to [Online monitoring
and control] in the [Device] menu.
The system enters offline mode.
2
Select [File] menu > [Save as].
The current configurations are saved as a settings file.
Note
When saving transmitter settings, make sure that the
transmitters are active and that signals are received
properly. If the information is not received properly from
a transmitter, the factory default settings of that transmitter
will be saved.
Opening files and editing settings
1
Remove the check mark next to [Online monitoring
and control] in the [Device] menu.
The system enters offline mode.
2
Select [File] menu > [Open].
3
Select the previously saved file, and click [OK].
The information stored in the file is displayed on the
Wireless Studio screen.
4
Edit the setting values.
Settings values can be edited in the [Property] window
or the [Property List] tab of the sub window.
For details on changing the settings, see "[Property
List] Tab" on page 33 and "[Property] Window" on
page 44.
When you are finished editing, save the settings to a file if
necessary.
21
Advertisement
Table of Contents
