Advertisement
in weak signal areas).
FM stereo reception is noisy.
The FM STEREO indicator flickers on and
cff and reception is noisy.
There is distortion and clear reception
cannot be obtained even with a good FM
antenna,
No stereo effect even with a stereo broad-
cast.
A desired station cannot be tuned in with
Auto Tuning.
Previously preset stations can no longer be
tuned in.
Insufficient sensitivity,
A, desired station cannot be tuned in with
Auto Tuning.
There are continuous crackling and hissing
noises.
There are buzzing and whining noises
(especially in the evening).
Cracking sounds from time to time (especially
nearest Yamaha dealer
The FM antenna should be put up as high as possible, away
from the road, and a coaxial cable should be used.
Ignition noise from vehicles.
Attach a nojise suppressor to the equipment causing the
naise.
Check the antenna connections.
Try using multiple element
FM antenna.
Press the TUNING
MODE
key so that the TUNING
MODE
indicator goes out CMAN' L, FM MONO setting).
Noise from thermostats or other electrical equipment.
Because of the characteristics of FM stereo broadcasts,
this is limited to cases where the transmitter is far away
or the antenna input is poor,
Use an antenna appropriate for the reception conditions
in your area,
Insufficient antenna input.
Station not tuned correctly.
Multipath interference,
Tune in correctly.
Adjust antenna
placement to eliminate multipath inter-
ference,
Press the TUNING
MODE
key so that the TUNING
MODE indicator lights up ("AUTO" setting).
The TUNING MODE indicator does not light (i.e, the
"MAN'L, FM MONO" setting is set).
The station is too weak.
Use a high-quality directional FM antenna.
Use Manual
tuning mode,
The tuner has been unplugged for a long period.
Repeat the preset procedure,
Weak
signal or loose antenna connections.
Tighten the AM
loop antenna connections and rotate
the antenna for best reception.
Use an outdoor antenna.
Use an outdoor antenna and a groundwire. This wil! help
somewhat but it is difficult to eliminate all noise.
These noises result from lightning, fluorescent lamps,
motors, thermostats and other electrical equipment.
Another station is interfering with the received station.
This is impossible to remedy.
A television set is being used nearby.
Move the television and tuner apart.
Before assuming that your tuner is faulty, check the following troubleshooting list which details corrective action you
can
take yourself without
having to call a service engineer,
If you
have any doubts or questions, get in touch with your .
10
Advertisement
