Download Print this page

Fine Tuning; Preset Station - Yamaha T-1020 Owner's Manual

Natural sound am/ fm stereo tuner
Hide thumbs Also See for T-1020:

Advertisement

æ
PRESET Tuning
The PRESET
STATION
key can be used to select, at a
single touch, any desired station which has been preset by
Manual, Auto Search or Fine Tuning.
To program the PRESET MEMORY
The following
exampie
is for an
FM
station to be
programmed to PRESET STATION key P1. (P11)
1.
Press tre FM/AM
key to set the FM band.
2. Set the RECEIVING
MODE,
TUNING
MODE
and
FINE
TUNING
keys according to the reception
conditions.
3. Tune ir the desired station.
4. Press the P1 — P10/P11 —P20 SELECTION
key to set
the P1 — P10 range.
5.
Press the MEMORY
key and then, while the indicator
is flickering about 5 seconds, press the P1 (P11) preset
key. Tre MEMORY
indicator will go out and the P1
(P11} indicator will light.
6. That FM station is now preset, including the reception
mode conditions, to preset key P1 (P11). To confirm
the setting, press another PRESET
STATION
key and
then press PRESET STATION
key P1. (P11)
You can confirm the frequency and reception mode as
they will be displayed.
e
AM stations can be programmed in the same way after
the AM band is set,
e
inthis way as many as 20 stations (both AM and FM
total) can be programmed at random for preset tuning.
e
To change the setting
for any key, follow the same
procedure.
The new
setting will be programmed
in
place of the former one,
e
After the P1 —
P10 presets
have been
programmed
completely, pressing the P1 — P10/P11 — P20 SELEC-
TION
key will enable the P11 — P20 preset station
range to be programmed,
PRESET
EM!
EM2
FMI
FM4
FMS
AMS
PI
Pit
Pe
piz
e3
m3
Pa
Pia
PS
P15
naa
|
_\\
e
ile the A
indicatori is lit press
| PRESET STATION
key.
"E
Using the Station Cards
Station Cards as shown below come with the T-1020.
Blank station cards are provided for you to fill in
according to the particular stations in your area you
wish to program
into the preset memory. They can
be changed freely.
inserting, replacing station cards:
1.
Remove the card holder,
Remove the
attached card,
. After appropriately labelling a station card,
remove
it from the film sheet and attach
it to
the card holder.
Card Holder
-rear side

Advertisement

loading