Connecting Power Supply; Using The Security Bar And Slot - Hitachi ED-D10N User Manual

Setting up

Connecting power supply

1.
Put the connector of the power cord into the
AC IN (AC inlet) of the projector.
2.
Firmly plug the power cord's plug into the
outlet. In a couple of seconds after the
power supply connection, the POWER
indicator will light up in steady orange.
Please remember that when the DIRECT POWER
ON function activated (47), the connection of the
power supply make the projector turn on.
WARNING
incorrect or faulty connections may result in fire and/or electrical shock.
• Only use the power cord that came with the projector. If it is damaged, consult
your dealer to get a new one.
• Only plug the power cord into an outlet whose voltage is matched to the power
cord. The power outlet should be close to the projector and easily accessible.
Remove the power cord for complete separation.
• Never modify the power cord.

Using the security bar and slot

A commercial anti-theft chain or wire up to
10 mm in diameter can be attached to the
security bar on the projector.
Also this product has the security slot for
the Kensington lock.
For details, see the manual of the security
tool.
WARNING
from falling down, since it is not designed for it.
CAUTION
may become too hot.
NOTE
• The security bar and slot is not comprehensive theft prevention
measures. It is intended to be used as supplemental theft prevention measure.
14
►Please use extra caution when connecting the power cord, as
Anti-theft chain or wire
►Do not use the security bar and slot to prevent the projector
►Do not place anti-theft chain or wire near the exhaust vent. It
AC IN
Security slot
Power cord
Security bar