Advertisement
CONNECTIONS
*See page 14 for details on antenna connections.
CONNECTING
SPEAKER WIRES
Antenna ground
1. Strip off the vinyl covering and twist the strands together.
Although
grounding
is not always
necessary
for reception,
it is
recommended
for protection against damage from lightning if an
outdoor
FM antenna
is used. Grounding is recommended as well
to help reduce noise and hum.
NOTE:
Never make the ground connection to a gas pipe as sparks could
cause the gas to ignite.
2. Raise the lever in the direction of the arrow and insert
the exposed conductor into the hole.
3. Now return the lever to its original position to secure
the cord.
Antenna ground
hd
Insert the TX-1210Z furnished connector obliquely from
above, and push it down until it locks, thus ensuring thatit
is connected. When disconnecting the connector, pull it in
the opposite direction while pressing the left and right
claws.
NOTE:
Do
not allow any of the cord's conductors
to protrude from the
terminals
or
touch
any
other
conductors.
Malfunctioning
or
breakdowns
may occur
when
conductors
come
into contact with
each other,
About Speaker Impedance
When
speaker
systems
are connected
to only one of the -
SPEAKERS A, B terminals, such speakers should have rated
impedance in the range of 8 — 162.
NOTE:
will be no sound.
Turn ON only the selector to which the speaker system is con-°
nected,
NOON
Speaker system A
(L)
Speaker system B
Multi-Room remote input jack (See page 6.)
Cas
/
Nlustration not applicable to U.K. Models
'
/
if
CONNECTING
THE
POWER
CORD
Household electrical outlet.
/
(For U.S. and Canadian models)
¢
ra
Household electrical outlets are provided with specific polari-
[> Long slot is negative (ground) side.
eee
4
ty, a positive side and a negative (ground) side. This unit
utilizes such polarity in order to improve sound quality. As
shown
in the illustration, be sure to insert the power plug
so that its blades match the width of slots in the outlet.
5
<ARB1160>
Advertisement
