Before Using; Package Contents; Items You Will Need That Are Not Included - Yamaha SW1000XG Owner's Manual

Before Using

Package Contents

Before using your new SW1000XG, check that all the items below are included in the package. In
the rare case that some item is missing, contact the store where you purchased your sound card
as soon as possible.
SW1000XG sound card
• MIDI adapter cable
• Plug-in board connection cable
• Spacers for plug-in board
CD-ROM
Owner's Manual (this book)

Items You Will Need that Are Not Included

To use your SW1000XG sound card and the included software, you will also need the following
hardware and software:
Computer:
If the Windows 95 version installed on your computer is OSR2 or higher, you can use IRQ shar-
ing. Because versions of Windows 95 earlier than that do not allow IRQ sharing, conflicts with
other boards may happen or installation may not be possible. Should this occur, change the IRQ
settings or remove the conflicting board.
n
You can check which version of Windows 95 is installed on your computer by clicking [My Computer], then
[Control Panel], then [System]. If the version number displayed on the [General] page is 4.00.950 B, you have OSR2.
If the number is 4.00.950 or 4.00.950 A, you have a previous version of Windows 95.
(1)
(1)
(4)
CPU/Memory
Hard Disk
CD-ROM Drive
Mouse
PCI Expansion Slot
Operating System
An IBM compatible personal computer
with a 166 MHz or higher Pentium CPU,
and at least 32 MB of memory.
To use the software included with
SW1000XG, the software and drivers must
be installed. To install and use the soft-
ware, at least 20 MB of hard disk space is
required.
All the software that came with your sound
card is included on the supplied CD-ROM.
To install the software and to read the
demo songs, a CD-ROM drive is required.
Operations in the included software are
mainly done using a mouse.
To install the sound card, an empty PCI
slot is required.
Windows 95 is required.
6