Yamaha SW1000XG Owner's Manual page 35

Audio Preset Dialog
Audio Source
Category List
Effect List
Audio Source Category List
Displays the category of the audio signal. In order to apply appropriate effects to the
audio signal, one of the categories on this list must first be selected by clicking on it.
Once a category is selected, a list of effect names included in that category will appear
in the effect list below. The following six categories are available for each part.
Mic ...............This category is appropriate for vocals or live instruments.
Guitar ............This category is appropriate for the sound of an electric guitar.
Keyboard ......This category is appropriate for keyboard sounds (mono) such as synthesizers.
Audio ............This category is appropriate for general line input (mono).
Stereo Keyboard ...This category is appropriate for keyboard sounds (stereo) such as synthesizers.
Stereo Audio ...This category is appropriate for general line input (stereo).
Effect List
This displays the effect names included in the category selected in the audio source cate-
gory list. Select the effect you want to use by clicking on it in the list. The effects dis-
played here will vary according to the category selected above.
Part Select Box
Click on the box, then from the drop-down list that is displayed, select the part number for
the audio category list and the effect list. Two parts can each be displayed at one time.
n
In all, parts 1 to 14 can be selected. The far left side on the audio part unit (
numbered in order from left to right. The far right side on the audio part unit is part 14.
Click Monitor
When this box is checked by clicking on it, you can hear the selected effect the moment
you click on it in the effect list.
Set each item by clicking on it, then click on [OK]. The dialog will close and the settings will
take effect. To cancel the operation before finishing it, click [Cancel]. The dialog will close,
and the settings will stay in their original state.
n
For parts where the audio signal from the external audio input (A/D input) terminal is input to the SW1000XG
sound card (parts that have A1 or A2 displayed in the input column of the part unit), even though an effect is
applied with this dialog, and the part is recorded on an XGworks wave track, the effect will not be recorded
together with the audio signal. When the recorded wave track is played back, only the raw sound without the
effects will be heard.
To output the same effects that existed when the song was recorded, the same effects must be set, even for audio
signal parts output from an XGworks wave track (parts that have P1 to P12 displayed in the Input column).
35
Part Select Box
Click Monitor
P. 36) is part 1. They are