Yamaha K-1020 Owner's Manual page 6

PEAK METER
The PEAK LEVEL will be displayed during the RECORD or PLAY
COUNTER
The elapsed PLAY time of the tape is TR
57--- MEMORY .
"MEMORY" will light up when a memory setting is made.
Cancelling the memory setting will cause the "MEMORY"
display to go out.
--- 0-М REPEAT
Turning оп 0-М Repeat will cause the GorSecondine display to light
up. Cancelling O-M Repeat will cause it to go out.
FULL REPEAT
Turning on Full Repeat will cause the corresponding display to light
up. Cancelling Full Repeat will cause it to go out.
|| r1 MEMORY
RIGHT
= | | ІШІ
TEST] [вошнсЕ)
[BAS ен) COE
Ј обе Је ] [хону
т TEC
NOISE REDUCTION Indicator
This indicator shows what type of noise reduction system is being
used.
FILTER Indicator
This indicator will light up when the MPX FILTER SWITCH is on.
BIAS
Indicates direction of tuning for optimum bias setting.
— MONITOR Indicator
This will indicate either the TAPE or SOURCE
MONITOR position. TAPE Indicator
This indicator will automatically үк the type of tape being used
when a cassette is loaded into the unit (auto tape selector).
Refer to the section "CASSETTE TAPES" on page14.
TEST Indicator
This indicator will light up during the ORBIT operation (bias
adjustment). It will flicker during the STANDBY mode.
REC Indicator
This indicator will light up during the RECORD and REC/PAUSE
modes. It will flicker during the AUTO REC MUTE mode.
ePrecision of Counter
The tape counter is not a clock, and so there will be some errors in
the time display compared to the actual recording time (this cannot
be avoided, as a suitable method is adopted to provide a time
display not only during recording and playback, but also during fast
forward and rewind). The error depends on the type of tape being
used.
The table below shows the range of error in the counter display
compared to actual tape travel time, for Yamaha tapes run from
beginning to end. It may be taken as a reference when using the
counter.
Range of error in display compared to travel time of
one side of tape |
(for Yamaha cassette tapes)
CR-90/MR-90
2 —— — —- bm
NR-60/CR-X60/MR-60
NR-90/NR-X90
Time displayed is
too short
(Unit: min.) Time displayed,is
ісо long.