JVC GR-SXM915 Instructions Manual page 19

19
Tape remaining time indicator
Recording Start/Stop Button
DISPLAY
Button
(Now calculating)
!
120MIN
119MIN
t
3MIN
2MIN
(Blinking)
1MIN
(Blinking)
1
OMIN
(Blinking)
I TOP RECORDING
Press the Recording StaWStop Button again to stop
recording.
, Time camcorder re-enters the Record-Standby mode.
NOTES:
• When the Power Switch is set to CAMERA and the LCD
monitor is opened at an angle of 60 degrees or more, the
LCD monitor switches on and the viewfinder switches
off automatically to save powel:
• The cassette hokler cmmot be opened unless a power
supply is attached.
• There may be a delay after you slide EJECT until the
holder opens. Do not use force.
• The tape remaining time is only displayed in the
viewfinder as shown.
• The remaining time indicated in the viewfinder is
approximate.
• The time required to calculate the remaining tape
length, and the accuracy of the calculation, may vary
according to the type of tape used.
|
• The tape remaining time indicator is correct only if the
correct tape length has been selected _ pg. 12).
• "TAPE END" appears when the tape reaches its end, and
the power goes off automatically if left in this condition
for 5 minutes. "TAPE END" also appears when a cassette
whose tape is already at its end is loaded.
• If the RecordStandby mode continues for 5 minutes
without performing Zoom or any other operations, the
camcorder'spower shuts off automatically. Set the
Power Switch to "POWER OFF", and then back to
"CAMERA" to turn the camcorder on again.
• If the Recording Start/Stop button is pressed after the
Record-Standby mode has continued for over
5 minutes, recordiny_ may not start immediately.
• If you are recordingon acassette from the middle (such
as when a tape is removed and re-inserted during
recording), use the Retake function _zg pg. 23) to find
the end of the last recording so you don't erase any of it.
• The LENS COVER warning blinks for about 5 seconds
when the camcorder is turned on with the cover closed.
• While shooting, sound is not heard from the speaker.
• To turn the tally lamp off during recording, refer to pgs.
,32 and ,34.
LCD Monitor/Viewfinderindications
Press DISPLAY to make the following indications a ppea r/
disappear from time camcorder's display: cassette warning,
tape remaining time, battery pack remaining power
indicator and tape length indicator (_,2_pg. 55).
I RESS DISPLAY BUTTON
l-o turn off time indications, press DISPLAY for more
than 1 second.
Press again for more than 1 second to make the
indications reappear.
NOTE:
Even if the indications are off, the tape remaining time
appears blinking when the tape is near its end, and the
battery pack remaining power indicator appears blinking
when the power is almost gone.