Installing The Interface Cable In An Lcc Socket Assembly - HP 10312D Operating Manual

Installing the
Interface Cable in
an LCC Socket
Assembly.
The LCC adapter supplied with the interface is designed to plug into
an IDT 3M Textool socket assembly (part no. 268-5400-52) or
equivalent socket assembly.
To connect the microprocessor connector to the target system LCC
socket assembly:
1. Remove the 80286 microprocessor from the target system
microprocessor socket.
2. Store the microprocessor in a protected environment.
3. Place the LCC adapter in the target system microprocessor socket
(see figure
1~3).
Take care to align the interface connector with the adapter
and the adapter with the target system socket so that all
microprocessor contacts are maldng contact. Also, take care
to note the position of pin I on the interface connector, LCC
adapter, and target system socket prior to connecting them.
4. Install the U-shaped IC retainer on top of the bottom board of the
LCC adapter and secure it
by
swinging the swivel lock up and over
the end of the U-shaped IC retainer.
Analyzing the Intel 80286
1-9