Installing Accessories - HP 3314A Manual

Installation
K. Replace all covers and then connect the power
cord. All X3 PC Assemblies were fully tested at the fac-
tory, however, the Performance Tests should be per-
formed to verify that the X3 Output is fully operational.
2-13. RE-PACKAGING À 3314A
The best material to re-pack a 3314A is the original
material used by the factory. If this material has not
been retained, the following steps should be performed:
1. Wrap the 3314A in heavy paper or plastic. If you
are shipping the 3314A to a -hp- office, attach one of
the Service Repair Tags. The front panel should also be
protected with an additional piece of cardboard.
2. Use a strong shipping container. A double wall
carton made of 350 pound test material is adequate.
4. Seal the shipping container.
5. Mark the shipping container FRAGILE to ensure
careful handling.
6. In any correspondence, refer to the 3314A by its
full serial number.
2-14. INSTALLING ACCESSORIES. A8
-hp- manufactures several kits to adapt your 3314A with
handles, feet and rack mounts. These kits are available
from -hp-.
5 1/4 H Front Handle Kit 5061-9689 Option 907
5 1/4 H Rack Adapter Kit 5061-9657 Option 908
(Half Module)
5 1/4 H Support Shelf Kit 5061-0097
Slide Kit 1494-0041
(For Support Shelf)
Lock Link Kit 5061-0094
(Vertical and Horizontal)
5 1/4 H Bail Handle Kit 5061-2002
(Half Module)
Feet-Rear Panel Stand-Off 5061-2009
Feet-Rear and Cord Wrap 5061-0095
2-6
Model 3314A