Sony SRK-R201 User Manual

HD INPUT BOARD
SRK-R201
HD OUTPUT BOARD
SRK-R202
日本語
電気製品は、 安全のための注意事項を守ら
ないと、 火災や人身事故になることがあり
ます。
ご使用にあたっては、
SR-R1000
ˎ ˎ
ンマニュアルの 「安全のために」 をよくお読みください。
本機を誤って装着すると、 火災・感電やその他の事故に
ˎ ˎ
より、 けがをしたり周辺の物品に損害を与えたりするこ
とがあります。危険を避けるため、 装着はサービスト
レーニングを受けた技術者にご依頼ください。
本機を装着する技術者のかたへ
装着の前に、 本機に付属の
ˎ ˎ
必ずお読みください。
基板の取り付けは、
SR-R1000
ˎ ˎ
めてから行ってください。
ご注意
本機を取り付けるときは、 必ず
にしてください。
OFF
取り扱い
取り扱い方法については、
ニュアルをご覧ください。
English
Precautions
If this unit is installed incorrectly, personal injury or
INSTALLATION GUIDE
1st Edition
2011.08.32
© 2011 Sony Corporation Printed in Japan
に付属のオペレーショ
INSTALLATION MANUAL
の電源を切り、 内部が冷
の主電源スイッチを
SR-R1000
のオペレーションマ
SR-R1000
Japanese/English
damage to peripheral items may occur due to fire, shock,
or other accidental circumstances. To avoid such risks,
installation should be performed by trained service
technicians.
To the technician installing the unit
Please refer to the INSTALLATION MANUAL supplied
ˎ ˎ
with this product for installation instructions.
Before installing the unit, be sure to turn off the
ˎ ˎ
SR-R1000 and wait until the internal temperature drops.
Note
Turn the SR-R1000's main power switch off before installing this
product.
Operation
Refer to the SR-R1000's OPERATION MANUAL for
instructions on how to operate this product after
installation.
For the customers in the U.S.A.
This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when
the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may cause
を
harmful interference to radio communications. Operation
of this equipment in a residential area is likely to cause
harmful interference in which case the user will be
required to correct the interference at his own expense.
You are cautioned that any changes or modifications
not expressly approved in this manual could void your
authority to operate this equipment.
All interface cables used to connect peripherals must be
shielded in order to comply with the limits for a digital
device pursuant to Subpart B of Part 15 of FCC Rules.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
4-284-756-01(1)
この説明書は、 再生紙を使用しています。
Printed on recycled paper.
http://www.sony.net/