Black & Decker BEGAS5800 Original Instructions Manual page 9

Danger - rotating blades. Keep
hands and feet out of openings.
Do not use the tool in wet
conditions or expose it to rain.
Wear safety glasses or goggles
when operating this appliance.
Wear suitable ear protectors
when operating this appliance.
Always remove the plug from
the socket before cleaning or
maintenance. Be careful not to
use your appliance if the cable is
damaged.
Disconnect the mains plug if
>
the cord becomes damaged or
entangled.
Wait until completely stopped
before touching.
Beware of flying objects. Keep
bystanders away from the
cutting area.
Wear gloves when operating this
tool.
Do not use as a step.
Directive 2000/14/EC guaran-
teed sound power.
(Original instructions)
Electrical safety
Warning! Warning! This product
must be earthed. Always check
that the power supply
corresponds to the voltage on the rating
plate.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Electric safety can be further improved
u
by using a high sensitivity 30 mA
Residual Current Device (RCD).
Features
This appliance includes some or all of the following features.
1. On/off switch
2. Direction selector
3. Overload protection button
4. Funnel
5. Stand
6. Collection bin
7. Adjustment knob
8. Plunger
9. Appliance inlet (for use on European models only which
are not supplied with a power cable)
Assembly
Warning! Before assembly, make sure that the appliance is
switched off and unplugged.
Attaching the wheels to the stand
(Fig. A1 & A2)
Turn the stand upside down and slide the wheel axle (11)
u
into the axle tube
Fit a washer (14) and a wheel bearing (13) onto each end
u
of the axle.
Fit the wheels (12) onto the axle (11), making sure to face
u
them as shown in figure A2.
Fit a washer (14a) on the outside of each wheel.
u
secure the wheels in place with the nuts (10).
u
Fit the hub caps (9).
u
Secure the feet (16) onto the stand (5) using the screws
u
with washer and lock washer (18) as shown in figure A1
Attaching the motor unit to the stand (Fig. B)
Align the holes on the motor unit with the corresponding
u
holes on the stand (5).
ENGLISH
9