Ec4: Ags Current Sensor Faulty Error; Ef1: Drain Hose Blocked/Kinked/Too High; Drain Filter Clogged/Dirty; Ef2: Excessive Detergent Dosing; Drain Hose Kinked/Blocked; Drain Filter Dirty/Clogged; Ef3: Aqua Control Device Triggered - Electrolux EWM0931 Series Service Manual

Hide thumbs

Table Of Contents

Table of Contents

EC4

Checks to perform:

Replace the main PCB and run the diagnostic cycle to check for any further alarms.

EF1

EF1: Drain hose blocked/kinked/too high; drain filter clogged/dirty

This warning only appears at the end of the cycle. The appliance detected long drainage phases during

the cycle. (E.g.: More than 20 seconds when draining after rinses). Check/clean the drain filter.

EF2: Excessive detergent dosing; drain hose kinked/blocked; drain

EF2

This is an excessive detergent dosing warning. The system detected too much foam was forming during

the drain phases. Advise the Customer to use the correct quantity of detergent and to make sure the

EF3

This warns about the presence of water at the bottom of the appliance. Check for any water leaks and

It can also be caused by excessive overheating of the drain pump. Check for any items which may

EF5

This is an unbalanced load warning. The appliance detected an extremely unbalanced load during the

spin phases. Advise the customer to load more washing into the drum and not just individual garments.

EF6

No action to be performed, if continues, replace the main PCB

2010 SOI/DT-mdm FCPD-dp Quality-tb

Guide to diagnostics for electronic controls EWM0931x