Table of Contents
Advertisement
4.2.4
Rapid reading of alarms
The last alarm can be displayed even if the programme selector is not in the tenth position (diagnostics) or if
the appliance is in normal operating mode (e.g. during the execution of the washing programme):
→ Press the START/PAUSE button and the nearest option button simultaneously (as if you were
entering DIAGNOSTIC mode) for at least 2 seconds: the LEDs initially switch off, and then display
the flashing sequence indicating the last alarm.
→ The alarm continues to be displayed for the amount of time required, and then the display returns to its
normal operation.
→ The alarm reading system is as described in para. 4.2
→ While the alarm is being displayed, the appliance continues to perform the cycle or, if in the programme
selection phase, it maintains the previously selected options in memory.
4.2.5
Deleting the last alarms
Before deleting any alarms, make a note of the last alarm on the "Service Order" form.
•
Delete them after reading them, to check whether the alarms re-occur during the diagnostic cycle.
•
Delete them after repairing the appliance, to check whether they re-occur during testing.
A 3 – Z 3
1. Select diagnostic mode, turn the programme
selector to the tenth position (reading of alarms)
2. Press the START/PAUSE button and the
nearest option button simultaneously (as
shown in the figure).
3. Hold down the buttons until the LEDs stop
flashing and the LCD display shows "E00" (at
least 5 seconds).
N.B. This operation will also delete all the stored alarms.
2010 SOI/DT-mdm FCPD-dp Quality tb
Guide to diagnostics for electronic controls EWM0931x
A 5 / 6 – Z 5 / 6 – K 6.2
1. Select diagnostic mode, turn the programme
selector to the tenth position (reading of alarms)
2. Press the START/PAUSE button and the nearest
option button simultaneously (as shown in the
figure).
3. Hold the buttons down until the LEDs stop
flashing (at least 5 seconds).
14/67
599 72 97-24
Advertisement
Table of Contents
