Table of Contents
Advertisement
Auto Term(J)
end
ClearTerm(K)
(Cont'd)
InhSlfT~t<L>
E5c XferOD
I nhDcT5t(W)
FldSeperetor
Configuring the Terminal
Table 2-2. Terminal Configuration Menu Fields (Continued)
The Auto Term(J) parameter only has an effect when the
II
key is pressed in block mode.
AutoTerm(J) • YES
Insert a non-displaying terminator at the current cursor position and then move the cursor
backward to the previous displaying or non-displaying terminator (if none is found, the cursor
moves back to the "home" position).
AutoTerm(J) • NO
Do NOT insert a non-displaying terminator and do NOT movE!. the cursor backward.
CleerTerm(K) • YES
If the display transfer operation is terminated by encountering a non-displaying terminator, clear
the terminator.
ClearTerm(K)
=
NO
Do NOT clear any non-displaying terminators.
Defaults: Auto Term(J) • NO
CleerTerm(K) • NO
This field is the functional equivalent of keyboard interface strap L on an HP
2645
terminal.
YES • The Power-On Test, Terminal Test, and Manufacturing Test are enabled (refer to section IX of
this manual).
NO • The Power-On Test, Terminal Test, and Manufacturing Test are all disabled. Any attempt
to initiate these tests (including an <ESC)z sequence) results in the "FUNCTION LOCKED" error
message; the terminal operator clears the message by pressing _ . The data comm self-
test is not affected by this field.
Default: NO
This field is the functional equivalent of keyboard interface strap N on an HP
2645
terminal.
YES • When transferring data between display memory and an external printer, escape sequences
relating to the display (such as those specifying display enhancements, format mode fields,
and alternate character sets) are sent to the external printer if encountered within the
data.
NO • Escape sequences relating to the display are not sent to the external printer.
Default: NO
This field is the functional equivalent of keyboard interface strap Won an HP
2645
terminal.
YES
=
The data comm self-test is enabled (refer to section IX of this manual).
NO • The data comm self-test is disabled. Pressing the" DATACOMMTEST" (m) function key (in the
"5ervice keY5"set) or issuing an <ESC)x results in the "FUNCTION LOCKED" error message; the
terminal operator clears the message by pressing _ .
Default: NO
When yOu press the
II
key while the terminal is in block page mode and display memory contains
a formatted display, the terminal automatically transmits the specified field separator character at
the end of each unprotected field (except the final one).
Value: Any ASCII character
Default: <US)
2-7
Advertisement
Table of Contents
