Table of Contents
Advertisement
The following accessories are available for the HP R85026A detector:
HP 11679A.7.6 metre (25 foot) extension cable
HP 11679B .61 metre (200 foot) extension cable
HP 11548A.R-Band waveguide holder (used with waveguide stand)
HP 11540A.Waveguide stand. Locks waveguide holder at any
height from 70 to 133 mm (2.7 to 5.25 in)
HP R362A.Waveguide Low Pass Filter
HP R365A.Isolator. Faraday-rotation-type
HP R910A .
Fixed Load
HP R896A.....Standard Section
HP R897A/B...Waveguide 90° Bend (E-Plane/H Plane)
HP R898A/B.Waveguide 90° Twist (R.H./L.H.)
HP R899A/B.Waveguide Straight Section (2.5 cm, 1 in/5.0 cm, 2 in)
HP R914A.
Sliding Load
HP R920B.
Moving Short
HPR921A.Flat Short
The equipment required for testing and/or troubleshooting the HP R85026A is listed in Table 1-2. Other
equipment may be substituted if it meets or exceeds the critical specifications indicated in the table.
INITIAL INSI^ieTION
If the shipping container or cushioning material is damaged, keep it until the contents of the shipment
are checked for completeness, and the instrument is checked both mechanically and electrically.
1.
Check the package for completeness. Figure 1-1 shows the items you should receive with each detector.
2.
Check connector, cable, and body for mechanical damage.
3.
Test the detector electrically. Refer to OPERATOR'S CHECK in Section II.
Notify your nearest Hewlett-Packard office if any of the following conditions exist:
• The instrument does not pass the performance tests and using the procedures in Section IV, Service,
you cannot correct the problem.
• The shipping contents are incomplete.
• There is mechanical damage or defect.
Also, notify the carrier if the shipping container is damaged or if the cushioning material shows signs of
stress. Keep all shipping materials for the carrier's inspection. Hewlett-Packard will arrange for repairer
replacement without waiting for a claim settlement.
Genera! Information
Advertisement
Table of Contents
