Table of Contents
Advertisement
SETUP
V i dee 2 Auto
L ink
Use this function to automatically turn the TV on and tune to Video 2 when it detects a video signal to
input 2.
r
•
:
•
•
i
Use THUMB STICK .a., "I', .41,I_ then press down on THUMB STICK to change AUTO LINK setting.
When AUTO
is selected, the TV will turn on and switch to Video2 automatically, when the Video2 input device is turned on. This is corn
venient when you want to watch a movie with your VCR, _aserdisc player, or DVD player.
When REMOTE is selected, the TV will turn on and switch to Video2 automatically when the Video2 input device is turned on (VCR
laserdisc, or DVD) and any of the buttons on your remote control is pressed.
Select Off to disable this function.
Press EXIT to quit the menu.
NOTES:
1.
Once the TV has been turned on using the AUTO LINK feature, it must be reset before AUTO LINK is used again. To
do this, turn your VCR, laserdisc, or DVD player OFF This feature is now reset and will turn on your Tv' as described
above.
2.
When using REMOTE
mode, any remote control button will substitute
for your video input device play button.
However, intended operation is for use with your VCR, laserdisc, or DVD play button.
3.
If no remote control button is pressed after the TV is turned on by AUTO LINK, the TV will automatically turn off after
three hours.
Set
The Color
System
J
This function allows you to automatically change tint and color coordinates for DTV programs.
AUTO _Automatically
determines the color system for the input signal.
HDTV - High Definition Television - Use for High Definition Signal Y-PBPR from HD]S,/SebTop
BOX.
SD]S,//DVD _Standard Definition Television or DVD (Digital Versatile Disc Player) Y-CBCR.
I
NOTES:
1. If Color System is set improperly (does not match actual input signal), the color and tint of the main picture will be
J
abnormal.
I
2. All component color system settings will affect only color component input you are currently viewing.
If you are using
both sets of component input jacks, be sure to set the color system feature for both inputs
Set
Black
Side
Panel
] The BLACK SIDE PANEL function turns the gray side bars on/off when watching
4:3 signals in
Standard
mode.
When the Plasma Television
is powered OFF, BLACK SIDE PANEL feature will be set to OFF
automatically
when the TV is powered ON. BLACK SIDE PANEL feature needs to be set every
time the TV is turned ON.
The top/bottom
gray bar will appear in SPLIT MODE PIP and SPLIT FREEZE.
NOTE:
I
To prevent screen burn when watching 4:3 signal, turn off the BLACK SIDE PANEL.
it is recommended
to watch 4:3
J
signa_ with gray side bar
I
62
Advertisement
Table of Contents
