Advertisement
Connections
Connection Examples
LINE OUT
LINE OUT
If your amplitier is not equipped with digital signal jacks
-——
: Analog signal
—
: Digital signal
(coaxial cable or optical cable)
—
: Signal flow
CD player
DIGITAL OUT
DAT deck
DIGITAL OUT
60ES,
OPTICAL) of the DTC-
{
b
b
Amplifier
=
:
=
om | Fe
i
When recording via digital-|
When recording via digital-
to-digital connection,
i
to-digital connection,
| connect a DAT deck (the
|
connect the sound source
REC OUT
digital input) to DIGITAL
equipment (the digital
OUT (COAXIAL or
output) to DIGITAL IN
(COAXIAL or OPTICAL) of
the DTC-60ES
DTC-60ES
When connecting a microphone
Connecting a stereo microphone amplifier (the analog
output} to LINE IN of the DTC-60ES.
=>
tO a wall outlet
Note
|f COPY PROHIBIT" appears in the display window.
recording via digital-to-digital connection cannot be
performed.
In this case, connect the sound source equipment using
LINE IN and OUT jacks.
16
Clock Setting
This unit uses a built-in clock to keep track of the current
date and time. Once you set the date and time. this
information will be recorded on the tape along with the
audio signal during recording, allowing you to check the
recording date of the tape during playback at a later time.
etting the Date and Time
1 with the unit stopped, press the CLOCK SET
button.
The year display begins to flash.
2
Press 9 (-) or 0 (+) to decrease or increase the
displayed item, then press the CLOCK SET button.
The next item begins to flash
3
Repeat step 2 until ail items have been set.
For greater accuracy, set the seconds display to zero,
then press the CLOCK SET button in synchronization
with a timecast (from the telephone or other time
source).
To confirm the date or time
Press the PRESENT button to display the date, the day of
the week or time. When pressing the PRESENT button
once, the date is displayed, when pressing twice, the day
of the week is displayed and when pressing three times,
the time is displayed. To return to the original counter
display, press the COUNTER MODE button
Time display
The time is displayed in 12-hour format.
Midnight and noon are displayed as follows
Midnight: 12:00 AM
Noon:
12:00 PM
Built-in clock
This unit's built-in clock operates using a quartz oscillator,
and time variations caused by changes in temperature,
etc., may accumulate.
For precise recording of hour,
minute, and second data by the built-in date function, it is
recommended that you set the clock once a week.
Precautions when setting the clock
* Set the clock while the tape is stopped
* Although this unit's clock automatically adjusts for leap
years and long and short months, do not enter a date
which does not exist.
The day of the week is displayed as follows:
Note
This unit uses a back-up battery to keep the clock running
when the power is turned off. The life of the battery under
normal use is approximately seven years. When the battery
Starts to run down, the clock will stop operating normally.
When this occurs, have the battery replaced at your dealer
or nearest Sony Service Center (a battery replacement fee
is required).
17
Advertisement
