Bosch Climate 5000 VRF FSC-B Series Installation & User Manual page 9

7.6 Control
Please number the indoor units during the installation. For example,
for the first outdoor unit, the number of the first indoor unit is 1-1,
the second indoor unit is 1-2, and the set address is 1 and 2
respectively, the others is analogical.
7.7 Horsepower set
Horsepower code
POWER_S
ENC1
Based on different purposes to setting the switch cords on PC panel
of indoor electrical control box. Once finish the setting, please
switch off the main power, and then input power again, other wise,
the setting function could not work.
Table 7-2
ENC1 Toggle switch
Code
0
Note: The horse-
1
power has been
set before leaving
2
the factory, only
3
competent and
qualified personnel
4
may adjust.
5
6
CAUTION
The total system number of units is 64 (0–63), each unit has only
one system address code. If two addresses are then same in one
system, the abnormal operation will occur.
Please switch off the power before setting,otherwise an error will
occur.
Climate 5000 VRF
Fig. 7-3
For set horsepower
Capacity (Horsepower)
2.2KW (0.8HP)
2.8KW (1.0HP)
3.6KW (1.2HP)
4.5KW (1.5HP)
5.6KW (2.0HP)
7.1KW (2.5HP)
8KW (3.0HP)
7.8 Network address set
1) Network address is set by communication of indoor and outdoor
unit; the address is the same as indoor address, there is no need
to set separately.
2) The central control of indoor units can be done on outdoor unit,
there is no need to control indoor unit separately, for details
please refer to V4+ outdoor unit manual.
3) For previous control of indoor units, the network can be set by
connecting (X,Y,E) terminals, there is no need to set network
address. The network can also be set by outer network module
and main board (CN20).
WIRING | 9
6720866023 (2017/11)