Before the following disassembly, disconnect all power to the heater and shut off the water supply to the heater.
1. Top cover and Front panel
• Remove the 6 screws that fasten the top cover. (See Figure 1)
• Remove the top cover.
• Remove the front décor. (There are 4 hooks.)
• Remove the 4 screws that fasten the front panel. (See Figure 2)
• Lift the front panel out. (Lift right side first.)
• Disconnect the connector between the front panel and control box.
• Re-install the components by referring to the removal procedure, above.
2. Rear panel
• Remove the top cover and front panel. (Refer to section 1)
• Remove the 2 screws that fasten the rear panel at both sides.
• Remove the 2 screws that fasten the rear panel at back.
• Lift the rear panel out. (See Figure 3)
• Re-install the components by referring to the removal procedure, above.
3. Control box
• Remove the top cover and front panel. (Refer to section 1)
• Remove the 1 screw that fasten the control box cover.
• Remove the control box cover. (There are 3 hooks.) (See Figure 4)
• Re-install the components by referring to the removal procedure, above.
4. Motor and Fan
• Remove the top cover, front panel, and rear panel. (Refer to section 1, 2)
• Remove the 2 screws that fasten the bracket. (See Figure 5)
• Remove the bracket.
• Remove the 4 screws that fasten the motor bracket.
• Lift out the motor bracket, motor, and fan. (See Figure 6)
• Remove the 2 screws and the nut that secure the motor and fan.
• Separate the motor bracket, motor, and fan.
• Re-install the components by referring to the removal procedure, above.
DISASSEMBLY
-11-
(Figure 1)
(Figure 3)
(Figure 5)
Copyright © 2023 LG Electronics Inc. All rights reserved.
(Figure 2)
(Figure 4)
(Figure 6)
Only training and service purposes.