Advertisement
•
After maintenance, do a check of the vibration level
in the product. If it is not correct, speak to an
approved service center.
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
To do before you operate the product
•
Read the operator's manual carefully and make sure
that you understand the instructions.
•
Read the engine manual that is supplied by the
engine manufacturer.
•
Do the daily maintenance. Refer to
schedule on page 10 .
To start the product
1. Open the fuel valve.
2. Set the throttle control to ⅓ throttle.
3. Set the choke control in the correct position.
a) If the engine is cold, close the choke.
b) If the engine is warm or the ambient temperature
is high, open the choke.
1652 - 001 - 03.05.2021
•
Operation
4. Set the engine ON/OFF switch to "ON".
5. Pull the starter rope handle slowly until you feel
Maintenance
6. Release the starter rope handle to let the starter
7. Pull the starter rope handle until the engine starts.
8. Open the choke control gradually until it is fully open.
1/3
9. Let the engine operate at idle speed for 2–3 minutes.
10. Set the throttle control to full throttle.
Let an approved service center do servicing on the
product regularly.
resistance.
rope go back.
9
Advertisement
