Advertisement
(A) and the vibration damping units (B)
are correctly installed and not damaged.
To safety the product to a transportation
vehicle with tie-down straps
•
Put 2 straps (A) around the bottom plate.
a) Put 1 strap around the front of the bottom plate
and attach the strap to the vehicle.
Technical data
Net weight, kg/lb
Operation weight (EN500, incl. oil, ½ fuel), kg/lb
Engine brand, type
Engine power, kW/hp @rpm
Vibration frequency, Hz/rpm
Amplitude, mm/in.
Centrifugal force, kN/lbf
Operation speed, m/min or ft./min
Max. tilt, degrees/%
Fuel tank capacity, l/qts
1
As specified by the engine manufacturer. The power rating of the engine indicated is the average net output
(at specified rpm) of a typical production engine for the engine model measured to SAE standard J1349/
ISO1585. Mass production engines may differ from this value. Actual power output for the engine installed on
the final product will depend on the operating speed, environmental conditions and other values.
1652 - 001 - 03.05.2021
A
Technical data
1
b) Put 1 strap around the rear of the bottom plate
and attach the strap to the vehicle.
Storage
•
Remove all fuel from the fuel tank before you put the
product in storage for a long period of time. Discard
the fuel at an applicable disposal location.
•
Clean the product before storage. Remove oil and
dust from the rubber parts.
•
Clean the air filter before storage.
•
Carefully pull the starter rope handle until there is a
small resistance. This closes the valves and makes
sure that moisture cannot go into the engine
cylinder.
•
Put a protective cover on the product.
•
Keep the product in a dry and frost free area.
•
Keep the product in a locked area to prevent access
for children or persons that are not approved.
Disposal
•
Obey the local recycling requirements and applicable
regulations.
•
Discard all chemicals, such as engine oil or fuel, at a
service center or at an applicable disposal location.
•
When the product is no longer in use, send it to a
Husqvarna dealer or discard it at a recycling
location.
99/218
100.4/221.3
Honda GX160
3.6/4.8 @3600
90/5400
2/0.079
18/4047
28 or 92
20/36
3.6/3.8
15
Advertisement
